What Did You Do To Your Car Today?

[El Andrew]

Worse case for your yours is to throw in a built motor.

Thanks gents. Actually I read about wrapping a chain around the broken bits and hooking the puller into that, so might give that a go before I start cutting the jaws. If I do end up cutting the pulley and it falls in the sump, we will both have clunks going over speed jumps but for different reasons.

Nice work on the Integra

[El Andrew]

$45 Amazon bearing separator kit FTW

Attempt 1 must have at least got it moving as it pulled off real quick just using a ratchet spanner

[El Andrew]

Went to fit that Raceworks push in breather adaptor but wouldn't fit - presumably due to my double powder coating.

So I just pushed the hose into the port on the cover and wondered why I didn't just do that the first time...

[Slowxr6t]

that's a fairly agricultural fix lol, just poke the hose in the hole.

[El Andrew]

I could add the factory clamp, but it is nice and snug and will just be annoying when I remove the coil cover.

Next time the rocker cover is off I might buzz it back and install the fittings.

[Puffwagon]

Rear shocks arrived for my car today. I'll chuck them in when it's not raining.

[Tom Tucker]

Bit of momentum gathering to get her running again? 

[Puffwagon]

Nah this is for the na beast. It has 367xxxkm so everything is worn out. Still cheaper to fix it as it needs it, than to rebuild the turbo car.

[Puffwagon]

Ball joints are finally arriving today, what a farkup that was. Anyhow they are arriving this morning and it's pissing rain.

[Puffwagon]

They sent the wrong ones...