Jump to content

Recommended Posts

  • Manual mode ________________________ All day, erryday
  • Legacy Donating Member
  • Member For: 18y 8m 8d
  • Gender: Male
  • Location: Probably above atmospheric pressure
Posted

Turns out I just wasn't blowing hard enough to force air through the little valve I discovered in this Y piece.  Ball held in place by a spring, I thought it was a stone or a bit of the pump at first hahaha

 

kmwqMC7.jpg

 

 

zVaR7um.jpg

hIP6MNS.jpg

 

 

OgNjZQk.jpg

 

 

 

I flushed the valve anyway by using the plastic syringe filled with hot detergent water (in the kitchen sink, since I own the house I can do what I like cchhyyeeahhhh boiiiiiiii).

 

 

Hopefully I can get a new pump later today.

 

 

 

jMqbmyL.jpg

 

 

 

  • Like 2
  • 2 weeks later...
  • Legacy Donating Member
  • Member For: 11y 3m 10d
  • Gender: Male
  • Location: Canberra ACT
Posted

Got a hot dog chucked in the EL today in place of the stuffed muffler. System is now original Tickford exhaust manifold (nothing special), 100 cell cat, hot dog, rear resonator. Sounds brilliant. Loud under load but acceptable on idle. Set off two car alarms at work. Had a nice crackle at the exhaust shop when the guy gave it a big old rev and then lifted of.

  • Like 2
  • Legacy Donating Member
  • Member For: 18y 8m 24d
  • Gender: Male
  • Location: left right out
Posted

Took the t across the pits for its yearly, and discovered the fog switch is looking iffy.

Fogs on as it came into the pits, then bloke asks me, "how do you get the fogs going- I  had them going before?"

Push fog switch off and on again, a second later it works- weird.

I can jiggle the switch and they flicker a bit, so is this something others have experienced before?

Hoping its a switch or relay not something more expensive.

  • Manual mode ________________________ All day, erryday
  • Legacy Donating Member
  • Member For: 18y 8m 8d
  • Gender: Male
  • Location: Probably above atmospheric pressure
Posted

Switches pull straight out from the dash don't they?  Have a gander, maybe just a loose wire?

  • Like 1
  • Legacy Donating Member
  • Member For: 18y 8m 24d
  • Gender: Male
  • Location: left right out
Posted

Heres hoping Steve, really want to save a few bucks for a redo of the coldside pipe, always pissed me off how rapids pipes touched the bumper back and foul the spotty.

Hmmm, better check for worn wires on that spotty too..

  • flame magnet
  • Legacy Donating Member
  • Member For: 18y 2m 16d
  • Gender: Male
  • Location: adelaide hills- 'race air' central
Posted

easy fix- put an fg typhoon bumper on- so much room behind there... :pandalol:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...