Jump to content

Recommended Posts

  • ...JD TUNING ADELAIDE...
  • Legacy Donating Member
  • Member For: 18y 1m 21d
  • Gender: Male
  • Location: Adelaide
Posted

2nd that lol 

  • Legacy Donating Member
  • Member For: 21y 14d
  • Gender: Male
  • Location: OZ
Posted

The guys who do the scrutineering are pretty ruthless and your car needs to be in race ready condition with no oil leaks, full brake pads etc.  I nearly didn't pass and only had one shot at scrutineering as I was heading overseas and arrived back in Australia the day of Racewars (...then had a wedding on that day so missed the first day).

 

I was told to fix a very small leak on the turbo oil return and install new brake pads, however I had zero time and managed to talk them into re-checking the car on the second day of Racewars. I fixed the issues and they passed me but with all the commotion I forgot to load in the high speed tune lol.  My only 1000m run didn't gain any mph over the 800m so I knew I had an issue, so I left it there and went home. It wasn't until I sucked the tune out with HP afterwards that I found out I f**ked up.  Worst part is I hounded Stever to get his tuner to remove his  limiter haha.

 

Anyway, valuable lesson.  For those who are entering, make sure the car is in tip top condition and don't skimp on a decent tyre!!

 

So the list so far is:

 - EFFXR6T

 - Turboknapp

 - Stever

 - IH8TOADS

 - mummba

 

I'd be keen to organise a decent sized house if any others are!?  Accommodation will probably book out fairly quick towards the end of the year as it's going to be a decent sized event!

 

 

  • Like 2
  • Legacy Donating Member
  • Member For: 19y 3m 29d
  • Gender: Male
  • Location: perth w.a
Posted
15 minutes ago, IH8TOADS said:

The guys who do the scrutineering are pretty ruthless and your car needs to be in race ready condition with no oil leaks, full brake pads etc.  I nearly didn't pass and only had one shot at scrutineering as I was heading overseas and arrived back in Australia the day of Racewars (...then had a wedding on that day so missed the first day).

 

I was told to fix a very small leak on the turbo oil return and install new brake pads, however I had zero time and managed to talk them into re-checking the car on the second day of Racewars. I fixed the issues and they passed me but with all the commotion I forgot to load in the high speed tune lol.  My only 1000m run didn't gain any mph over the 800m so I knew I had an issue, so I left it there and went home. It wasn't until I sucked the tune out with HP afterwards that I found out I f**ked up.  Worst part is I hounded Stever to get his tuner to remove his  limiter haha.

 

Anyway, valuable lesson.  For those who are entering, make sure the car is in tip top condition and don't skimp on a decent tyre!!

 

So the list so far is:

 - EFFXR6T

 - Turboknapp

 - Stever

 - IH8TOADS

 - mummba

 - Wiggum*

I'd be keen to organise a decent sized house if any others are!?  Accommodation will probably book out fairly quick towards the end of the year as it's going to be a decent sized event!

Fixed 

15 minutes ago, IH8TOADS said:

 

 

  • Legacy Donating Member
  • Member For: 21y 14d
  • Gender: Male
  • Location: OZ
Posted
19 minutes ago, Ralph Wiggum said:

*cough*

 

I'll take that as a yes lol.

  • Member
  • Member For: 12y 9m 22d
Posted

I know most of you bloke are on antilag and probably seen the plans for the grudge racing Saturday night. So who's keen to be called out? Haha me and toads should have ago since we are both manual the winner will probably be whoevers diff stays in the car off the line lol.

  • Like 1
  • Moar Powar Babeh
  • Legacy Donating Member
  • Member For: 20y 9m 29d
  • Gender: Male
  • Location: Perth
Posted

Well Toads should  have his IMS diff hat installed by then and already has some pretty stout half shafts. Driveshaft however.....

  • Member
  • Member For: 12y 9m 22d
Posted

Damn well he has me on diff strength least I'll have him on tailshaft strength lol. Guess I better put some 31splines axle and brace the diff housing for 20psi 2 step launches.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...